MCQs in Electrical Circuit Part V

(Last Updated On: December 8, 2017)
Electrical Circuit - MCQS Part V

This is the Multiples Choice Questions Part 5 of the Series in Electrical Circuit as one of the Electronics Engineering topic. In Preparation for the ECE Board Exam make sure to expose yourself and familiarize in each and every questions compiled here taken from various sources including but not limited to past Board Exam Questions in Electronics Engineering field, Electronics Books, Journals and other Electronics References.

Multiple Choice Questions Topic Outline

  • MCQs in AC-DC circuits
  • MCQs in Resistors
  • MCQs in Inductors
  • MCQs in Capacitors

The Series

Following is the list of multiple choice questions in this brand new series:
Electrical Circuit MCQs
PART 1: MCQs from Number 1 – 50                        Answer key: PART I
PART 2: MCQs from Number 51 – 100                   Answer key: PART II
PART 3: MCQs from Number 101 – 150                 Answer key: PART III
PART 4: MCQs from Number 151 – 200                 Answer key: PART IV
PART 5: MCQs from Number 201 – 250                 Answer key: PART V
PART 6: MCQs from Number 251 – 300                 Answer key: PART VI

Continue Practice Exam Test Questions Part 5 of the Series

201. The distance between the capacitor plates increases two times, then its capacitance

  • A. Increases two times
  • B. Increases four times
  • C. Decreases two times
  • D. Decreases four times

202. The ratio between the active power and the apparent power of a load in an ac circuit is called

  • A. Quality factor
  • B. Power factor
  • C. Power ratio
  • D. Power reactive

203. When the power factor of a circuit is zero,

  • A. Power absorbed is maximum
  • B. Power absorbed is minimum
  • C. Power absorbed is zero
  • D. The impedance is minimum

204. How many degrees of phase represents one full cycle?

  • A. 360
  • B. 180
  • C. 270
  • D. 90

205. Which of the following does not generally affect the value of a capacitor?

  • A. The dielectric material used
  • B. The surface area of the plates
  • C. The thickness of the dielectric
  • D. The voltage applied to the plate

206. What is the purpose of a load in an electric circuit?

  • A. To increase the circuit current
  • B. To decrease the circuit current
  • C. To utilize electrical energy
  • D. To make the circuit complete

207. The power factor of a certain circuit in which the voltage lags behind the current is 80 %. To increase the power to 100 %, it is necessary to add _____ to the circuit.

  • A. Inductance
  • B. Capacitance
  • C. Resistance
  • D. Impedance

208. Refers to the outward-curving distortion of the lines of force near the edges of two parallel metal plates that form a capacitor.

  • A. Skin effect
  • B. Night effect
  • C. Edge effect
  • D. Hall effect

209. If voltage across the plates of 2 F capacitor is increased by 4 V, then charge on the plates will

  • A. Decrease by 2 C
  • B. Increase by 2 C
  • C. Decrease by 4 C
  • D. Increase by 4 C

210. What does a capacitor store?

  • A. Voltage
  • B. Charge
  • C. Current
  • D. Power

211. The mutual inductance between two coils is _____ the reluctance of magnetic path.

  • A. Directly proportional to
  • B. Inversely proportional to
  • C. Independent to
  • D. Equal to

212. The result of rust in electrical (wire) connection is

  • A. Inductance
  • B. Conductance
  • C. Impedance
  • D. Resistance

213. Which of the following is a disadvantage of a wire-wound resistor?

  • A. It has reactance in radio-frequency circuits
  • B. It cannot handle much power
  • C. It draws a large amount of current
  • D. It cannot handle high voltage

214. The resistance of an insulator ___ when its temperature is increased.

  • A. Decreases
  • B. Remains the same
  • C. Increases
  • D. Varies

215. The wavelength of an alternating waveform depends upon the _____ of the variation.

  • A. Period
  • B. Number
  • C. Frequency
  • D. Amplitude

216. Delta to wye or wye to delta transformation technique is applied to a _____ network.

  • A. One-terminal
  • B. Two-terminal
  • C. Three-terminal
  • D. Complex

217. For greater accuracy, the value of phase angle θ should be determined from

  • A. Cos θ
  • B. Tan θ
  • C. Sin θ
  • D. Sec θ

218. Inductive reactance applies only to sine waves because it

  • A. Increases with lower frequencies
  • B. Increases with lower inductance
  • C. Depends on the factor 2 π
  • D. Decreases with higher frequencies

219. What increases the resistance of wire at high frequencies?

  • A. Temperature
  • B. Voltage
  • C. Skin effect
  • D. Insulation

220. An inductor carries 2 A dc. If its inductance is 100 μH, then what is its inductive reactance?

  • A. Zero
  • B. 1.3 kΩ
  • C. 628 Ω
  • D. -628 Ω

221. Barium-strontium titanite dielectric material is also called

  • A. Ceramic
  • B. Polyster
  • C. Electrolytic
  • D. Bakelite

222. In the 5-band method of capacitor color coding, the first band indicates

  • A. Temperature coefficient
  • B. Tolerance
  • C. 1st digit
  • D. Capacitance value

223. What is the most convenient way of achieving large capacitance?

  • A. By using multiplate construction
  • B. By using air as dielectric
  • C. By decreasing distance between plates
  • D. By using dielectric of low permittivity

224. A linear circuit is one whose parameters

  • A. Change with change in voltage
  • B. Change with change in current
  • C. Do not change with voltage and current
  • D. Change with change in voltage and current

225. For a linear circuit, _____ voltage or current is used to calculate average power.

  • A. Rms
  • B. Peak
  • C. Average
  • D. Instantaneous

226. When two coils of identical reactance are in parallel without mutual inductance, the reactance of the combination is _____ the reactance of each coil.

  • A. One half
  • B. Twice
  • C. Four times
  • D. One fourth

227. Which of the following is also known as anti-resonant circuit?

  • A. Parallel resonant circuit
  • B. Series resonant circuit
  • C. Tuned circuit
  • D. Tank circuit

228. In a complex number 5 + j 10, 10 is called _____ part.

  • A. Imaginary
  • B. Real
  • C. Conjugate
  • D. Integer

229. The presence of an electric current is made known by

  • A. Electric shock
  • B. Effects produced
  • C. Magnetic shock
  • D. Flashing

230. The reciprocal of a complex number is

  • A. A complex number
  • B. A real number
  • C. An imaginary number
  • D. A whole number

231. Which of the following has negative temperature coefficient?

  • A. Carbon
  • B. Nickel
  • C. Brass
  • D. Constantan

232. Which of the following is a common material used in wire-wound resistors?

  • A. Manganin
  • B. Carbon
  • C. Bronze
  • D. German silver wire

233. If one resistance in a series connection is open, then

  • A. The current is zero in all the other resistances
  • B. The current is maximum in all the other resistances
  • C. The voltage is zero across the open resistance
  • D. The voltage is infinite across the open resistance

234. What determines the magnitude of electric current?

  • A. The rate at which electrons are produced
  • B. The type of material used
  • C. The current carrying capacity of the circuit
  • D. The rate at which electrons pass a given point

235. For a carbon composition resistor, typical resistance values range from

  • A. 2.7 Ω to 22 MΩ
  • B. 1000 Ω to 10000 Ω
  • C. 10 Ω to 10 MΩ
  • D. 2.7 Ω to 2.7 GΩ

236. A lead conductor has a resistance of 25 Ω at 0 ˚C. Determine its resistance at -30 ˚C.

  • A. 22 Ω
  • B. 24 Ω
  • C. 12 Ω
  • D. 11 Ω

237. An impedance given by 90 -45˚ is a/an _____ impedance.

  • A. Inductive
  • B. Conductive
  • C. Resistive
  • D. Capacitive

238. If a coil has a Q of 10, it means that

  • A. The energy stored in the magnetic field of the coil is 10 times the energy wasted in its resistance
  • B. The energy wasted in its resistance is 10 times the energy stored in the magnetic field of the coil
  • C. It is a low Q coil
  • D. It is a high Q coil

239. What is the rms value of a square wave?

  • A. Equals its peak value
  • B. Equals its peak-to-peak value
  • C. Peak divided by square root of two
  • D. Peak divided by pi

240. The rms value of a triangular or sawtooth waveform is _____ times its peak value.

  • A. 0.577
  • B. 0.500
  • C. 0.25
  • D. 0.707

241. In a multiple capacitor, the plate area is

  • A. Increased
  • B. The same
  • C. Decreased
  • D. Variable

242. What is the time constant for L of 240 mH in series with R of 20 Ω?

  • A. 12 ms
  • B. 4.8 s
  • C. 83.3 s
  • D. 12 s

243. In an ac circuit, the power dissipated as heat depends on

  • A. Impedance
  • B. Capacitive reactance
  • C. Resistance
  • D. Inductive reactance

244. Which of the following dielectric materials makes the lowest-capacitance capacitor?

  • A. Paper
  • B. Mica
  • C. Air
  • D. Electrolyte

245. In adding or subtracting phasor quantities, ____ form is the most convenient.

  • A. Polar
  • B. Rectangular
  • C. Trigonometric
  • D. Exponential

246. In dividing or multiplying phasor quantities, _____ form is used.

  • A. Polar
  • B. Rectangular
  • C. Trigonometric
  • D. Exponential

247. The power factor of a circuit is equal to

  • A. RZ
  • B. XC/Z
  • C. XL/Z
  • D. R/Z

248. The capacitance of a capacitor is _____ relative permittivity.

  • A. Directly proportional to
  • B. Inversely proportional to
  • C. Equal to
  • D. Inversely proportional to the square of

249. If a multiplate capacitor has 10 plates, each of area 10 cm2, then

  • A. 10 capacitors will be in parallel
  • B. 10 capacitors will be in series
  • C. 9 capacitors will be in parallel
  • D. 9 capacitors will be in series

250. Of the equivalent combination of units, which one is not equal to watt?

  • A. Ω2/V
  • B. AV
  • C. A2Ω
  • D. J/s

Complete List of MCQs in Electronics Engineering per topic

credit: © 2014 www.PinoyBIX.org
MCQs in Electrical Circuit Part V
Rate this:

Add Comment

© 2017 PinoyBIX Engineering. © 2017 All Rights Reserved | Donate
Basic Television - Grob TV  Chapter Exercises
Basic Television – Grob TV Chapter Exercises
Series of Multiple Choice Questions in Engineering Mathematics
Series of Multiple Choice Questions in Engineering Mathematics
Complete Practice Quiz in Electronic Devices and Circuit Theory
Complete Practice Quiz in Electronic Devices and Circuit Theory
Complete Practice Quiz in Data Communications and Networking
Complete Practice Quiz in Data Communications and Networking
Online Tool: Color Code Conversions
Online Tool: Color Code Conversions
Online Tool: Weight Measurement Conversions
Online Tool: Weight Measurement Conversions
Online Tool: Temperature Measurement Conversions
Online Tool: Temperature Measurement Conversions
Online Tool: Length Measurement Conversions
Online Tool: Length Measurement Conversions

Get FREE Review Course
in your inbox

Subscribe to our mailing list and get reviewers and updates to your email inbox.

Thank you for subscribing.

Something went wrong.