MCQs in Electrical Circuit Part VI

(Last Updated On: December 8, 2017)
Electrical Circuit - MCQS Part VI

This is the Multiples Choice Questions Part 6 of the Series in Electrical Circuit as one of the Electronics Engineering topic. In Preparation for the ECE Board Exam make sure to expose yourself and familiarize in each and every questions compiled here taken from various sources including but not limited to past Board Exam Questions in Electronics Engineering field, Electronics Books, Journals and other Electronics References.

Online Questions and Answers Topic Outline

  • MCQs in AC-DC circuits
  • MCQs in Resistors
  • MCQs in Inductors
  • MCQs in Capacitors

The Series

Following is the list of multiple choice questions in this brand new series:
Electrical Circuit MCQs
PART 1: MCQs from Number 1 – 50                        Answer key: PART I
PART 2: MCQs from Number 51 – 100                   Answer key: PART II
PART 3: MCQs from Number 101 – 150                 Answer key: PART III
PART 4: MCQs from Number 151 – 200                 Answer key: PART IV
PART 5: MCQs from Number 201 – 250                 Answer key: PART V
PART 6: MCQs from Number 251 – 300                 Answer key: PART VI

Continue Practice Exam Test Questions Part 6 of the Series

251. A neon glow lamp used as a night light ionizes at approximately
  • A. 70 V
  • B. 80 V
  • C. 90 V
  • D. 100 V

252. What dielectric is generally employed by a variable capacitor?

  • A. Mica
  • B. Air
  • C. Electrolyte
  • D. Ceramic
253. A switch designed to have low capacitance between its terminal when open.
  • A. LOCAP switch
  • B. AntiLOCAP switch
  • C. Anticapacitance switch
  • D. Capacitance switch
254. A resistor wound with a wire doubled back on itself to reduce the inductance.
  • A. Bifilar resistor
  • B. Wire-wound resistor
  • C. Anti-inductive resistor
  • D. Bleeder resistor
255. What fusion of elements is without chemical action between them?
  • A. Mixture
  • B. Compound
  • C. Alloy
  • D. Ionization
256. In calculating maximum instantaneous power ___ voltage or current is used.
  • A. Peak
  • B. Average
  • C. Rms
  • D. Instantaneous
257. The area of capacitor plates increases two times, then its capacitance
  • A. Increases two times
  • B. Increases four times
  • C. Decreases two times
  • D. Decreases four times
258. If the inductance is decreased, the impedance of the circuit containing a resistor a capacitor and an inductor connected in series to an ac source
  • A. Decreases
  • B. Increases
  • C. Decreases or increases
  • D. Decreases, increases or remains the same
259. When the movable plates of a gang capacitor completely overlap the fixed plates, the capacitance of the capacitor is
  • A. Halfway between maximum and minimum
  • B. Maximum
  • C. Minimum
  • D. Zero

260. In a circuit, a passive element is one which

  • A. Supplies energy
  • B. Receives energy
  • C. Both supplies and receives energy
  • D. Attenuates signal

261. Rationalizing the denominator of a complex number means

  • A. Eliminating the j component in the denominator
  • B. Adding j component in the denominator
  • C. Eliminating the j component in the numerator
  • D. Adding j component in the numerator

262. When two complex conjugates are subtracted, the result is a

  • A. Quadrature component only
  • B. Complex component
  • C. In-phase component
  • D. Real component
263. A coil of inductance L has an inductive reactance of XL in an ac circuit in which the effective current is I. The coil is made from a superconducting material. The rate at which power is dissipated in the coil is
  • A. 0
  • B. I2XL
  • C. IXL
  • D. IXL2
264. If the capacitance of mica capacitor is 5 times the capacitance of air capacitor, then the relative permittivity of mica is
  • A. 2.5
  • B. 5
  • C. 10
  • D. 25
265. The hot resistance of an incandescent lamp is about ___ times its cold resistance.
  • A. 10
  • B. 5
  • C. 50
  • D. 100
266. When the temperature of copper wire is increased its resistance is

A. Increased
B. Decreased
C. Constant
D. Zero

267. A trimmer is a variable capacitor in which capacitance is varied by changing the
  • A. Number of plates
  • B. Dielectric
  • C. Distance between plates
  • D. Plate area
268. The reason why electrical appliances are not connected in series.
  • A. Greater electrical power saving
  • B. Power loss is minimum
  • C. Appliances have different current ratings
  • D. All of the above
269. Form its definition, the unit of electric field, is the N/C and equivalent unit of is the
  • A. V(m)2
  • B. V(m)
  • C. V/m2
  • D. V/m

270. Which of the following is the peakiest?

  • A. Square wave
  • B. Sinusoidal wave
  • C. Triangular wave
  • D. Rectangular wave
271. Why are inductance and capacitance not relevant in a dc circuit?
  • A. Because it is a simple circuit
  • B. Because dc circuits require only resistance as load
  • C. Because they do not exist in a dc circuit
  • D. Because frequency of dc is zero
272. When capacitors are connected in parallel, the total capacitance is
  • A. Greater than the largest capacitor
  • B. Smaller than the largest capacitor
  • C. Smaller than the smallest capacitor
  • D. Greater than the smallest capacitor
273. When current and voltage arte in phase in an ac circuit, the ___ is equal to zero.
  • A. Resistance
  • B. Reactance
  • C. Inductance
  • D. Capacitance
274. Thevenin’s theorem is what form of an equivalent circuit?
  • A. Current
  • B. Voltage
  • C. Both current and voltage
  • D. Neither current nor voltage
275. Which of the following combination of length and cross-sectional area will give a certain volume of copper the least resistance?
  • A. 2L and1/2 A
  • B. Does not matter because the volume of copper remains the same
  • C. L and A
  • D. ½ L and 2 A
276. The ratio between the reactive power and the apparent power of an ac load is called
  • A. Quality factor
  • B. Power factor
  • C. Power ratio
  • D. Reactive power
277. What is the efficiency under the conditions of maximum power transfer?
  • A. 50 %
  • B. 100 %
  • C. 25 %
  • D. 75 %
278. The charging of a capacitor through a resistance follows what law?
  • A. Linear law
  • B. Hyperbolic law
  • C. Inverse-square law
  • D. Exponential law

279. Norton’s theorem is what form of an ac equivalent circuit?

  • A. Voltage
  • B. Current
  • C. Both voltage and current
  • D. Neither voltage nor current
280. What is the total capacitance of 10 capacitors, each of 20 μF in series?
  • A. 200 μF
  • B. 2 μF
  • C. 100 μF
  • D. 0.5 μF

281. An inductive load always has a ___ power factor

  • A. Leading
  • B. Lagging
  • C. Zero
  • D. Unity
282. When resistance are connected in parallel, the total resistance is
  • A. Less than the smallest resistance in the connection
  • B. Greater than the smallest resistance in the connection
  • C. Between the smallest and greatest resistance in the connection
  • D. Increasing and decreasing depending upon the supply voltage
283. The arc across a switch when it open an RL circuit is a result of the
  • A. Large self-induced voltage across L
  • B. Long time constant
  • C. Low resistance of the open switch
  • D. Surge of resistance
284. What is a rotating vector whose projection can represent either current or voltage in an ac circuit?
  • A. Polar diagram
  • B. Scalar quantity
  • C. Velocity
  • D. Phasor

285. Which factor does not affect resistance?

  • A. Length
  • B. Resistivity
  • C. Cross-sectional area
  • D. Mass

286. Which of the following capacitors are used only in dc circuits?

  • A. Mica
  • B. Ceramic
  • C. Mylar
  • D. Electrolytic

287. The maximum power transfer theorem is used in

  • A. Power system
  • B. Electronic system
  • C. Refrigeration
  • D. Air conditioning

288. In Norton’s theorem, the short circuit current is obtained by

  • A. Opening the load terminals
  • B. Shorting the load terminals
  • C. Opening the voltage source
  • D. Shorting the voltage source
289. For maximum power transfer, what is the relation between load resistance RL and internal resistance R of the voltage source?
  • A. RL = 2 r
  • B. RL = 1.5 r
  • C. RL = r
  • D. RL = 3 r
290. A capacitor of 0.5 μF charged to 220 V is connected across an uncharged 0.5 μF capacitor. What is the voltage across each capacitor?
  • A. 220 V
  • B. 150 V
  • C. 110 V
  • D. 22 V
291. When capacitors are connected in series, the total capacitance is
  • A. Smaller than the smallest capacitor
  • B. Smaller than the largest capacitor
  • C. Greater than any of the capacitor
  • D. Greater than the largest capacitor
292. What theorem is generally used in the analysis of vacuum tubes?
  • A. Superposition theorem
  • B. Millman’s theorem
  • C. Thevenin’s theorem
  • D. Norton’s theorem
293. Another term of the quality factor of the resonant circuit.
  • A. Figure of merit
  • B. Figure of demerit
  • C. Noise factor
  • D. Noise figure
294. Which of the following represents the energy stored in a capacitor?
  • A. CV2/2
  • B. 2Q2/C
  • C. C2/V
  • D. CV
295. What theorem is usually used in the analysis of transistor circuit?
  • A. Superposition theorem
  • B. Millman’s theorem
  • C. Thevenin’s theorem
  • D. Norton’s theorem

296. Which of the following capacitors has the highest cost per μF?

  • A. Plastic
  • B. Air
  • C. Mica
  • D. Electrolytic
297. Under the conditions of maximum power transfer, a voltage source is delivering a power of 15 W to the load. What is the power generated by the source?
  • A. 60 W
  • B. 30 W
  • C. 15 W
  • D. 4 W
298. Which of the following is neither a basic physical law nor deliverable from one?
  • A. Ohm’s law
  • B. Coulomb’s law
  • C. Kirchhoff’s first law
  • D. Kirchhoff’s second law

299. Another term for superconductor.

  • A. Generic conductor
  • B. Ultraconductor
  • C. Cryotron
  • D. Cryogenic conductor

300. A circuit whose parameters change with voltage or current.

  • A. Non-linear circuit
  • B. Linear circuit
  • C. Complex circuit
  • D. Passive circuit

Complete List of MCQs in Electronics Engineering per topic

credit: © 2014 www.PinoyBIX.org
MCQs in Electrical Circuit Part VI
Rate this:

Add Comment

© 2017 PinoyBIX Engineering. © 2017 All Rights Reserved | Donate
Basic Television - Grob TV  Chapter Exercises
Basic Television – Grob TV Chapter Exercises
Series of Multiple Choice Questions in Engineering Mathematics
Series of Multiple Choice Questions in Engineering Mathematics
Complete Practice Quiz in Electronic Devices and Circuit Theory
Complete Practice Quiz in Electronic Devices and Circuit Theory
Complete Practice Quiz in Data Communications and Networking
Complete Practice Quiz in Data Communications and Networking
Online Tool: Color Code Conversions
Online Tool: Color Code Conversions
Online Tool: Weight Measurement Conversions
Online Tool: Weight Measurement Conversions
Online Tool: Temperature Measurement Conversions
Online Tool: Temperature Measurement Conversions
Online Tool: Length Measurement Conversions
Online Tool: Length Measurement Conversions

Get FREE Review Course
in your inbox

Subscribe to our mailing list and get reviewers and updates to your email inbox.

Thank you for subscribing.

Something went wrong.