MCQs in Electricity and Magnetism Fundamentals Part VI

(Last Updated On: December 8, 2017)
Electricity and Magnetism Fundamentals - MCQS Part VI

This is the Multiples Choice Questions Part 6 of the Series in Electricity and Magnetism Fundamentals as one of the Electronics Engineering topic. In Preparation for the ECE Board Exam make sure to expose yourself and familiarize in each and every questions compiled here taken from various sources including but not limited to past Board Exam Questions in Electronics Engineering field, Electronics Books, Journals and other Electronics References.

Multiple Choice Questions Topic Outline

  • MCQs in Atomic Structure
  • MCQs in Electric Charge
  • MCQs in Ohm’s Law, Kirchoff Law, Coulomb’s Law, etc
  • MCQs in Magnetic Power
  • MCQs in Magnetic Field and Magnetic Flux
  • MCQs in Magnetic and Electric Quantities / Units
  • MCQs in Magnetic/Electromagnet Principles

The Series

Following is the list of multiple choice questions in this brand new series:
Electricity and Magnetism Fundamentals MCQs
PART 1: MCQs from Number 1 – 50                        Answer key: PART I
PART 2: MCQs from Number 51 – 100                   Answer key: PART II
PART 3: MCQs from Number 101 – 150                 Answer key: PART III
PART 4: MCQs from Number 151 – 200                 Answer key: PART IV
PART 5: MCQs from Number 201 – 250                 Answer key: PART V
PART 6: MCQs from Number 251 – 300                 Answer key: PART VI

Continue Part 6 of the Series

251. The relation between absolute permittivity of air (ε0), absolute permeability of air (μ0) and velocity of light (c) is given by

  • A. μ0ε0 = c2
  • B. μ0ε0 = c
  • C. 1/μ0ε0 = c
  • D. 1/μ0ε0 = c2

252. The dielectric constant of most materials lies between

  • A. 1 and 10
  • B. 10 and 20
  • C. 20 and 50
  • D. 50 and 100

253. A test charge means a charge of

  • A. -1 C
  • B. 1 electron
  • C. +1 C
  • D. -20 C

254. Electric lines of force leave or enter the charge surface at an angle of

  • A. 30o
  • B. 45 o
  • C. 90 o
  • D. depending upon the angle of launch and entry

255. Electric field intensity is measured in

  • A. volts/meter
  • B. Newton/meter
  • C. Newton-meter
  • D. Amperes/meter

256. Electric field intensity is a ________.

  • A. scalar
  • B. phasor
  • C. vector
  • D. variable

257. Electric field intensity at a point due to a given charge ______ if the relative permittivity of the medium decreases.

  • A. decreases
  • B. remains unchanged
  • C. increases
  • D. becomes zero

258. The electric field intensity between the parallel plate air capacitor is 20 N/C. If an insulating slab of relative permittivity 5 is placed between the plates, then electric field intensity will be

  • A. 20 N/C
  • B. 100 N/C
  • C. 4 N/C
  • D. 40 N/C

259. The electric flux density is a ________ quantity.

  • A. phasor
  • B. vector
  • C. scalar
  • D. variable

260. The permittivity of a material is given by one of the following formulas.

  • A. DE
  • B. E/D
  • C. D^2/E
  • D. D/E

261. Electric field intensity at a point is numerically equal to ________ at that point.

  • A. potential gradient
  • B. potential difference
  • C. dielectric constant
  • D. the force

262. Three charges of +5 C, -6 C and +9 C are placed inside a sphere. What is the total flux passing through the surface of sphere?

  • A. 8 C
  • B. 14 C
  • C. 20 C
  • D. -6 C

263. The potential at a point due to a charge is 15 V. If the distance is increased three times, the potential at the point will be

  • A. 5 V
  • B. 18 V
  • C. 45 V
  • D. 15 V

264. Electric potential is a _______ quantity.

  • A. scalar
  • B. phasor
  • C. vector
  • D. variable

265. The electric potential at a point in air due to a charge is 21 V. If the air is replaced by a medium of relative permittivity of 3, then electric potential at that point will be

  • A. 63 V
  • B. 21 V
  • C. 7 V
  • D. 42 V

266. The electric potential across part AB of a circuit is 5 V; point A being at higher potential. If a charge of 5 C moves from A to B, then energy released as

  • A. 5 joules
  • B. 25 joules
  • C. 10 joules
  • D. 100 joules

267. What is the other name for dielectric strength?

  • A. Breakdown voltage
  • B. Electric intensity
  • C. Potential gradient
  • D. Dielectric constant

268. Which of the following materials has the highest dielectric strength?

  • A. Glass
  • B. Oiled paper
  • C. Mica
  • D. Air

269. What is used as the insulating material or dielectric in an electric ion?

  • A. Oiled paper
  • B. Mica
  • C. Paraffin
  • D. Titanate compound

270. What is used as the dielectric material in high voltage transformers?

  • A. Mica
  • B. Paraffin
  • C. Porcelain
  • D. Oiled paper

271. One farad equals

  • A. 1 coulomb/volt
  • B. 1 newton/coulomb
  • C. 1 newton-meter
  • D. 1 volt/second/ampere

272. Which of the following is used by permanent magnets as the magnetic material?

  • A. iron
  • B. nickel
  • C. soft steel
  • D. hardened steel

273. Which of the following is used by temporary magnets as the magnetic material?

  • A. Hardened steel
  • B. Cobalt steel
  • C. Soft iron
  • D. Tungsten steel

274. What is the main advantage of temporary magnets?

  • A. The magnetic flux can be changed.
  • B. Hysteresis can be decreased.
  • C. Magnetic materials can be used.
  • D. Abundance of ferromagnetic material that can be temporarily magnetized.

275. Permanent magnets can be found in

  • A. electric bells
  • B. earphones
  • C. relays
  • D. dynamic loudspeakers

276. Temporary magnets are commonly employed in

  • A. electric instruments
  • B. motors
  • C. moving coils loudspeakers
  • D. magnetos

277. The force between two magnetic poles is _______ their pole strengths.

  • A. directly proportional to
  • B. the sum of
  • C. inversely proportional to
  • D. the product of

278. If the distance between two magnetic poles decreases by 2 times, the force between them

  • A. decreases two times
  • B. increases four times
  • C. increases two times
  • D. decreases four times

279. The force between two magnetic poles is _____ the relative permeability of the medium.

  • A. directly proportional to
  • B. independent of
  • C. inversely proportional to
  • D. equal to

280. Two similar poles, each 1Wb, placed 1 m apart in air will experience a repulsive force of

  • A. 63000 N
  • B. 63 × 10^-3 N
  • C. 8 × 10^12 N
  • D. 796 kN

281. One weber of flux is equal to _______ magnetic lines of force.

  • A. 106
  • B. 1010
  • C. 4π × 107
  • D. 108

282. The unit of flux density is

  • A. Wb/m
  • B. Tesla
  • C. At/m
  • D. N/Wb

283. What is the typical saturation flux density for most magnetic materials?

  • A. 4 Wb/m2
  • B. 5 Wb/m2
  • C. 1 Wb/m2
  • D. 2 Wb/m2

284. Magnetic field intensity is a ________ quantity.

  • A. scalar
  • B. phasor
  • C. vector
  • D. variable

285. The force acting on a pole of 5 Wb is 25 N. What is the intensity of the magnetic field?

  • A. 5 N/Wb
  • B. 25 N/Wb
  • C. 125 N/Wb
  • D. 0.2 N/Wb

286. The relative permeability of a magnetic material is 10^5. What is its permeability?

  • A. 4π × 105 H/m
  • B. 4π × 10-12 H/m
  • C. 4π × 10-2 H/m
  • D. 4π × 10-7 H/m

287. Which of the following has the highest permeability?

  • A. Soft iron
  • B. Steel
  • C. Air
  • D. Permalloy

288. A magnetic pole produces 5000 field lines. How much is the flux in webers?

  • A. 50 × 10-6
  • B. 5 × 10-6
  • C. 500 × 10-6
  • D. 500 × 10-5

289. As the magnetic intensity decreases, the relative permeability of a magnetic material

  • A. decreases
  • B. remains the same
  • C. increases
  • D. becomes zero

290. The permeability of a material having a flux density of 5 Wb/m^2 is 10^-5 H/m. What is the value of magnetizing force?

  • A. 5 × 10-5 N/Wb
  • B. 500 × 103 N/Wb
  • C. 4π × 10-7 N/Wb
  • D. 4π × 107 N/Wb
291. When the relative permeability of a material is slightly less than 1, it is called _____ material.
  • A. diamagnetic
  • B. ferromagnetic
  • C. paramagnetic
  • D. non-magnetic

292. When the relative permeability of a material is slightly more than 1, it is called ______ material.

  • A. diamagnetic
  • B. ferromagnetic
  • C. paramagnetic
  • D. non-magnetic

293. Which of the following is a diamagnetic material?

  • A. Aluminum
  • B. Silver
  • C. Air
  • D. Cobalt

294. Which of the following is a paramagnetic material?

  • A. Carbon
  • B. Bismuth
  • C. Copper
  • D. Oxygen

295. The greater percentage of materials is _________.

  • A. diamagnetic
  • B. paramagnetic
  • C. ferromagnetic
  • D. non-magnetic

296. When the relative permeability of a material is much greater than 1, it is called _______ material.

  • A. diamagnetic
  • B. ferromagnetic
  • C. paramagnetic
  • D. non-magnetic

297. The flux density in an air-cored coil is 10^-3 Wb/m^2. With a cast iron core of relative permeability 100 inserted, the flux density will become

  • A. 10-3 Wb/m2
  • B. 10-2 Wb/m2
  • C. 103 Wb/m2
  • D. 0.1 Wb/m2

298. At/m is a unit of

  • A. mmf
  • B. magnetic force
  • C. reluctance
  • D. magnetic flux density

299. The direction of force o a current carrying conductor placed in a magnetic field can be found by

  • A. Cork screw rule
  • B. Fleming’s left hand rule
  • C. Fleming’s right hand rule
  • D. using a compass

300. When a current carrying conductor is placed in a magnetic field, the maximum force will act on the conductor when the conductor is at an angle of _______ to the magnetic field.

  • A. 45
  • B. 60o
  • C. 30o
  • D. 90o

Complete List of MCQs in Electronics Engineering per topic

credit: © 2014 www.PinoyBIX.org
MCQs in Electricity and Magnetism Fundamentals Part VI
Rate this:

Add Comment

© 2017 PinoyBIX Engineering. © 2017 All Rights Reserved | Donate
Basic Television - Grob TV  Chapter Exercises
Basic Television – Grob TV Chapter Exercises
Series of Multiple Choice Questions in Engineering Mathematics
Series of Multiple Choice Questions in Engineering Mathematics
Complete Practice Quiz in Electronic Devices and Circuit Theory
Complete Practice Quiz in Electronic Devices and Circuit Theory
Complete Practice Quiz in Data Communications and Networking
Complete Practice Quiz in Data Communications and Networking
Online Tool: Color Code Conversions
Online Tool: Color Code Conversions
Online Tool: Weight Measurement Conversions
Online Tool: Weight Measurement Conversions
Online Tool: Temperature Measurement Conversions
Online Tool: Temperature Measurement Conversions
Online Tool: Length Measurement Conversions
Online Tool: Length Measurement Conversions

Get FREE Review Course
in your inbox

Subscribe to our mailing list and get reviewers and updates to your email inbox.

Thank you for subscribing.

Something went wrong.