Practice Quiz in Digital and Data Communication Networks Part 17

(Last Updated On: December 20, 2017)

Quiz in Digital and Data Communication Networks

This is the Online Practice Quiz in Digital and Data Communication Networks Part 17 as one of the Communications Engineering topic. In Preparation for the ECE Board Exam make sure to expose yourself and familiarize in each and every questions compiled here taken from various sources including but not limited to past Board Examination Questions in Electronic System and Technologies, Communications Books, Journals and other Communications References.

Continue Part XVII of the Online Practice Quiz

Quiz in Digital and Data Communication Networks

Question 161. What is the category of data transmission if the binary pulse is maintained for the entire bit time?

A. Return to zero

B. Bipolar

C. Unipolar

D. Non – return to zero

Question 162. It is a system where the digital signals are placed directly on the coaxial cable.

A. Broadband

B. Baseband


D. Token ring

Question 163. A scheme in which several channels are interleaved and then transmitted together is known as

A. Frequency division multiplex

B. Time division multiplex

C. a group

D. a supergroup

Question 164. A signaling system in which each letter of the alphabet is represented by a different symbol is not used because

A. it would be too difficult for an operator to memorize

B. it is redundant

C. noise would introduce too many errors

D. too many pulses per letter are required

Question 165. The basic modulator and demodulator circuits in PSK are


B. Balanced modulators

C. Shift registers

D. Linear summers

Question 166. Pulse – amplitude modulation signals are multiplexed by using

A. Subcarrier

B. Bandpass filters

C. A/D converters

D. FET switches

Question 167. It is the thermal noise power normalized to 1-Hz bandwidth

A. power density ratio

B. thermal noise

C. noise power density

D. ambient temperature noise

Question 168. The slope of the analog signal is greater than the delta modulator can maintain

A. overload distortion

B. granular noise

C. slope overload

D. peak limiting

Question 169. It is the transmittal of digitally modulated analog signals (carrier) between two or more points in a communications system.

A. Digital modulation

B. Digital transmission

C. Data communications

D. Pulse modulation

Question 170. A pulse modulation technique as the width of a constant amplitude pulse is varied proportional to the amplitude of the analog signal at the time the signal is sampled.

A. Pulse Width Modulation

B. Pulse Length Modulation

C. Pulse Duration Modulation

D. All of these

List of Practice Quizzes

Practice Quiz in Digital and Data Communication Networks Part 17
Rate this:

Add Comment

© 2017 PinoyBIX Engineering. © 2017 All Rights Reserved | Donate
Basic Television – Grob TV Chapter Exercises
Series of Multiple Choice Questions in Engineering Mathematics
Complete Practice Quiz in Electronic Devices and Circuit Theory
Complete Practice Quiz in Data Communications and Networking
Online Tool: Color Code Conversions
Online Tool: Weight Measurement Conversions
Online Tool: Temperature Measurement Conversions
Online Tool: Length Measurement Conversions

Get FREE Review Course
in your inbox

Subscribe to our mailing list and get reviewers and updates to your email inbox.

Thank you for subscribing.

Something went wrong.