Practice Quiz in Digital and Data Communication Networks Part 21

(Last Updated On: December 20, 2017)

Quiz in Digital and Data Communication Networks

This is the Online Practice Quiz in Digital and Data Communication Networks Part 21 as one of the Communications Engineering topic. In Preparation for the ECE Board Exam make sure to expose yourself and familiarize in each and every questions compiled here taken from various sources including but not limited to past Board Examination Questions in Electronic System and Technologies, Communications Books, Journals and other Communications References.

Continue Part XXI of the Online Practice Quiz

Quiz in Digital and Data Communication Networks

Question 201. The most widely used data communications code is

A. Morse code


C. Baudot


Question 202. A special device that upgrades signals from one level to a higher level of the hierarchy in multiplexing

A. Muldem

B. Vocoder

C. Modem

D. Codec

Question 203. It is the measure of how much information can be propagated through a communication system and is a function of a bandwidth of the transmission line

A. information theory

B. information capacity

C. information technology

D. digital communications

Question 204. Indicate which of the following pulse modulation systems is analog



C. Differential PCM

D. Delta

Question 205. The technique of using modulation and FDM to transmit multiple data channels of a common medium is known as

A. baseband

B. broadband

C. ring

D. bus

Question 206. The ASCII code has

A. 4 bits

B. 5 bits

C. 7 bits

D. 8 bits

Question 207. The carrier used with a BPSK demodulator is

A. Generated by an oscillator

B. The BPSK signal itself

C. Twice the frequency of the transmitted carrier

D. Recovered from the BPSK signal

Question 208. Function of data link control that specifies the means of detecting and correcting transmission errors

A. Error control

B. Selection

C. Protocol

D. Synchronization

Question 209. Which of the following words has the correct parity bit? Assume odd parity. The last bit is the parity bit.

A. 1111111 1

B. 1100110 1

C. 0011010 1

D. 0000000 0

Question 210. Indicate the false statement. In order to combat noise,

A. the channel bandwidth may be increased

B. redundancy may be used

C. the transmitted power may be increased

D. the signaling rate may be reduced

List of Practice Quizzes

Rate this:

Add Comment

© 2014 PinoyBIX Engineering. © 2018 All Rights Reserved | How to Donate?
mcq in computer fundamentals
➡️ MCQ in Computer Fundamentals Series | ECE Board Exam
mcq in industrial electronics
➡️ MCQ in Industrial Electronics Series | ECE Board Exam
MCQ in Power Generators (Cells and Batteries) Part 5 | ECE Board Exam
➡️ MCQ in Power Generators, Sources, Principles, Applications Series | ECE Board Exam
mcq in electrical circuit
➡️ MCQ in Electrical Circuit Series | ECE Board Exam

Get FREE Review Course
in your inbox

Subscribe to our mailing list and get reviewers and updates to your email inbox.

Thank you for subscribing.

Something went wrong.